Nowadays, rapid rolling doors are widely used in various industries and fields. Different industries and fields to high speed door installation wall is also a variety of. There are mixed soil walls, there are steel walls, like these walls can be fixed fast rolling shutter door frame structure. Some walls are hollow brick, cold storage board, purification board, gypsum board light walls need to pay attention to. This wall is generally not very firm. The installation of the fast rolling shutter door a little bit bigger, it is easy to shake.
At this time it is necessary to reinforce the treatment, the general way of reinforcement is to use the square tube to do reinforcement. On each side of the doorway. A 10050 mm square tube, or 12060 mm square tube, as a reinforcement fixing point. The thickness should be more than 3 mm. For the environmental requirements of the higher places in the square tube with baking paint square tube. So that both beautiful and can reduce environmental pollution.
Correct installation of high speed door need to know what common sense?
- High speed door, also known as the rapid rolling door, generally we use in the field of electronics, food, chemical and other more common. And gives people work provides great convenience. Then the correct installation of the city’s rapid rolling doors need to know what common sense?
- Motor: the motor reducer should be installed to align the key strip mouth, threaded into the shaft head. With two L-shaped motor fixing plate, in order to motor reducer and iron plate vertical fixed firmly.
- Guide rail: you want to measure the height of the fast rolling shutter door. To use a level meter to determine the level of the line, hold the door body, with 8 * 100 within the explosion screws to fix the guide rail and stainless steel cover decoration.
- Track under the mouth of the corner code: track hanging good vertical line. In the track under the mouth of the installation of the corner code and fixed. Requirements: solid installation, vertical.
- The installation of photoelectricity: Measure 25 centimeters upward at the bottom of the track to determine the installation position of photoelectricity on both sides of the horizontal state. The photoelectric transmitter and photoelectric receiver reflector fixed in the photoelectric bracket, photoelectric bracket with 5 * 10 stainless steel screws.
- Control box: control box is installed in the motor side of the ground to the control box under the mouth 1.3m. Control box and the distance between the track is 10cm. radar line, motor line, photoelectric line, encoder and other wires from the threading pipe into the control box.
- Wiring and commissioning methods: the specific control box has a control wiring diagram. Please ensure that the line position should not be wrong.
- Box: the end of commissioning, the door body box cover with self-drilling screws. Motor cover cover good with expansion plugs fixed to the wall
- Contact SEPPES for more details